How to read a radon test result
Last checked November 19, 2026
How to interpret a radon number in pCi/L, when to average two short-term tests, what to do near 4 pCi/L, and when to retest.
A radon test result is usually a number in picocuries per liter of air (pCi/L). That number is an average over the time the device was in place, not a guarantee of the level on every day of the year.[1][2] Read it together with the kind of test that was used. For the difference between short-term and long-term tests, and for EPA's three real-estate testing options, see short-term vs. long-term radon tests.
The thresholds EPA and CDC use
EPA recommends fixing a home at 4 pCi/L or more, and considering a fix between 2 and 4 pCi/L, because there is no known safe level of exposure.[3] The average U.S. indoor level is about 1.3 pCi/L; outdoor air is about 0.4 pCi/L.[3][2] A fuller explanation is on EPA's radon action level.
Averaging two short-term tests
In a real estate transaction, EPA's buyer's guide treats two short-term tests — taken at the same time, or one immediately after the other — as a single decision: fix the home if the average of the two tests is 4 pCi/L or more. A single continuous monitor used for at least 48 hours is also enough, on that protocol, to decide whether to fix if its average is 4 pCi/L or more.[1]
CDC's testing page gives similar follow-up advice for a short-term result above 4 pCi/L: take a second test (short-term or long-term); if the second test is short-term, average the two; then contact a licensed professional if that average, or any long-term test, is at or above 4 pCi/L.[2]
When the number is close to 4
EPA says short-term tests are sometimes less definitive about whether the home is at or above 4 pCi/L, particularly when results are close to 4. Its example: if the average of two short-term tests is 4.1 pCi/L, there is about a 50 percent chance that the year-round average is somewhat below, or above, 4 pCi/L. EPA still says any radon exposure carries some risk, and that even levels below 4 pCi/L pose some risk.[1]
Pennsylvania's radon program offers a practical confirmation path for a first result of 4 to 8 pCi/L: a second long-term (365-day) test, or another short-term test of 2 to 7 days, and corrective action if the result is still 4 pCi/L or higher.[4] A long-term confirmation may not fit a closing timeline; in a purchase, EPA's short-term options above are the ones written for that setting.[1]
Check the conditions, not just the number
A result is only as good as the test behind it. On a short-term test lasting less than four days, EPA says windows and outside doors should have been closed at least 12 hours beforehand and kept closed except for normal entry and exit, and that you should not run such a short test during severe storms or high winds.[1] The device should have been in the lowest regularly usable level of the home, not in a kitchen, bathroom, crawl space, or closet.[1] If a report does not say where the test was placed, how long it ran, or whether closed-house conditions were kept, ask. Minnesota's real-estate guidance lists similar questions for reviewing a prior test, including whether it ran for the minimum time and whether a livable basement was tested.[5]
If the result is in working levels (WL) or Bq/m³ instead of pCi/L, see the unit conversions on the action level page.[6]
After a fix, or after you move in
EPA says you should test again after a home is fixed, to be sure levels have been reduced. If you later start occupying a lower level, such as a basement, retest on that level. It is also a good idea to retest sometime in the future to be sure levels remain low.[1] CDC says to retest a few months after the home is fixed, and its prevention page adds: consider retesting every two years, and also retest after any remodeling.[2][7] Pennsylvania similarly recommends a test generally in the basement, preferably during the heating season, once every two years after a system is installed.[4]
If the air result is elevated and the house has a private well, EPA says to test the water. See radon in well water.[1]
Sources
Every page below was fetched on November 19, 2026. If an official page has since changed, the official page wins.
- EPA, Home Buyer's and Seller's Guide to Radon (EPA 402/K-24/001, March 2024, revised) — PDF fetched November 19, 2026.
- CDC, Testing Your Home for Radon — Page states updated and reviewed August 26, 2026. Opened November 19, 2026 (the box curl was blocked with HTTP 403; the page was read through a fetch tool the same day).
- EPA, What is EPA's Action Level for Radon and What Does it Mean? — Page last updated October 13, 2026.
- Pennsylvania Department of Environmental Protection, Radon in the Home
- Minnesota Department of Health, Radon in Real Estate
- EPA, Explain Working Levels (WL) and Picocuries Per Liter of Air (pCi/L)
- CDC, Reducing Radon Levels in Your Home — Page dated June 18, 2026. Opened November 19, 2026 (box curl HTTP 403; read through a fetch tool the same day).
This page is a reading of official and reputable published pages, not legal, lending, medical, or engineering advice. Radon rules are set by states and sometimes by localities, and they change. Confirm anything that affects a sale or a loan with your state radon office, your lender, and your closing attorney or agent.